Description
Small Tips for YOU,please read before buying.
x Please Note that This Window Film Only Applies on Smooth Glass Surfaces.Do not Apply to Outside window or Windows with Crack.
x Don't forget to remove transparent backing side before putting on glass or it will not clingUse a tape on a corner of the back side the smooth side to quickly remove the backing protective film.
x Please use a hair dryer to soften the film under cold weather Heat Resistant up to 176℉
About this item
NO ADHESIVES WINDOW PRIVACY FILM: Glue Free Design Cuts down Chemical Release Drastically, Applies in Minutes and Firmly Sticks to Windows
EASY REMOVAL: Leaving No Residue after Removal and the Film Can Even Be Used Again!
UV PROTECTION AND ENERGY SAVING: Blocks up to 96 of UV Rays and Reduces Glare up to 79, Slows Down Fading on Flooring, Furniture, and Cuts Energy Bill up to 30 by Rejecting up to 45-85 of Total Solar Energy
RAINBOW EFFECT: When the Sun Shines Through, It Casts Lots of Rainbows, Creates the Appearance of Stained Glass and Adds an Attractive Design for an Updated Look
PRIVACY PROTECTION: Provides Privacy and Allows the Lights in. Privacy Level :★★★★☆ Semi-Private Window Films Protects Your Privacy But Not Recommended For Bathroom Application
STEP-BY-STEP INSTALLATION INSTRUCTIONS:
Measure and record the length and width of the glass surface.
Cut the film along the grid and add 1+ inch on every side when doing this so you have excess film to trim away.
lean the glass surface and the frame.
Peel the backing film off.
Generously spray the water on the static side of the film.
Lightly mist the glass.
Place the film on the wet window.
Use a plastic card to squeegee the water and air out under the film.
Use the plastic card to work the film into the edges as tightly as possible. Trim excess material away with a sharp razor, leaving a 1/16” wide gap around the four perimeter edges of the film.
Questions And Answers：
How to Peel Off the Clear Backing Film ？
（The hottest question）
Step 1 – Wet one window film corner and use your fingers to twist it for a while to loosen the attachment between the window film and clear backing film.
Step 2 – Please attach a
sticky tape
to the side of the clear backing film corner we have also attached a small green sticky tape on each roll of window film for your convenience, and then press it for effective attachment.
Step 3 – And then you are able to separate the clear backing film from the window film easily.
How to deal with the air bubbles?
If you find it's hard to get rid of the bubbles, uncover the window film, spray more water between the glass and the film and squeegee firmly again. Water will make it much easier to remove bubbles.
Why the film fall off after a while?
Please check if you have removed the liner, trimmed the edges or squeegeed excess water and bubbles.
Leave a 1/16” wide gap around the four perimeter edges of the film.
This gap is essential for the proper thermal expansion of the glass and allows you to completely squeegee the water and air from under the film.
Reviews
There are no reviews yet.